逆变器在我们生活中使用非常广泛，但是很多人并不能够正确使用逆变器，那么逆变器到底该如何使用呢？小编接下来就为您介绍一下。
逆变器的使用方法：
1、直流电压要一致每台逆变器都有接入直流电压数值，如12V，24V等，要求选择蓄电池电压必须与逆变器直流输入电压一致。例如，12V逆变器必须选择12V蓄电池。
2、逆变器输出功率必须大于电器的使用功率，特别对于启动时功率大的电器，如冰箱、空调，还要留大些的余量。
3、正、负极必须接正确逆变器接入的直流电压标有正负极。红色为正极（＋），黑色为负极（—），蓄电池上也同样标有正负极，红色为正极（＋），黑色为负极（—），连接时必须正接正（红接红），负接负（黑接黑）。连接线线径必须足够粗，并且尽可能减少连接线的长度。
4、应放置在通风、干燥的地方，谨防雨淋，并与周围的物体有500px以上的距离，远离易燃易爆品，切忌在该机上放置或覆盖其它物品，使用环境温度不大于40℃。
5，充电与逆变不能同时进行。即逆变时不可将充电插头插入逆变输出的电气回路中。
6、两次开机间隔时间不少于5秒（切断输入电源）。
7、请用干布或防静电布擦拭以保持机器整洁。
8、在连接机器的输入输出前，请首先将机器的外壳正确接地。
9、为避免意外，严禁用户打开机箱进行操作和使用。
10、怀疑机器有故障时，请不要继续进行操作和使用。
11、在连接蓄电池时，确认手上没有其它金属物，以免发生蓄电池短路，灼伤人体。
12、使用环境，基于安全和性能的考虑，安装环境应具备以下条件：
1）干燥：不能浸水或淋雨；
2）阴凉：温度在0℃与40℃之间；
3）通风：保持壳体上5CM内无异物，其它端面通风良好。
逆变器安装使用方法
1）将转换器开关置于关（OFF）的位置，然后把雪茄头插入车内点烟器插口，确保插到位而接触良好；
2）确认所有电器的功率在G－ICE标称功率以下方可使用，将电器的220V插头直接插入转换器一端的220V插座内，并确保两个插座所有连接电器的功率之和在G－ICE标称功率以内；
3）开启转换器开关，绿色指示灯亮，表示工作正常。
4）红色指示灯亮，表示因过压／欠压／过载／过温，导致转换器关断。
5）在很多情况下，由于车用点烟器插口输出有限，使得正常使用时转换器报警或关断，这时只要发动车辆或减小用电功率即可恢复正常。Inverters are widely used in our life, but many people can't use them correctly. So how to use inverters? The editor will introduce it to you next.
Use method of inverter:
1. The DC voltage should be consistent. Each inverter has the DC voltage value, such as 12V, 24V, etc. The battery voltage must be consistent with the DC input voltage of the inverter. For example, 12V battery must be selected for 12V inverter.
2. The output power of the inverter must be greater than the use power of the electrical appliances, especially for the electrical appliances with large power at startup, such as refrigerators and air conditioners, a larger margin should be left.
3. The positive and negative poles must be connected to the correct DC voltage connected to the inverter and marked with positive and negative poles. Red is positive (+), black is negative (-), and the battery is also marked with positive and negative electrodes, red is positive (+), and black is negative (-). The connection must be positive (red to red) and negative (black to black). The diameter of the connecting wire must be thick enough and the length of the connecting wire should be minimized.
4. It should be placed in a ventilated and dry place, beware of rain, and have a distance of more than 500px from the surrounding objects, far away from flammable and explosive materials. Do not place or cover other articles on the machine, and the ambient temperature should not be greater than 40 ℃.
5. Charging and inversion cannot be carried out at the same time. That is, the charging plug cannot be inserted into the electrical circuit of the inverter output during the inverter.
6. The interval between two starts shall not be less than 5 seconds (cut off the input power supply).
7. Please wipe with dry cloth or anti-static cloth to keep the machine clean.
8. Before connecting the input and output of the machine, please first properly ground the shell of the machine.
9. To avoid accidents, users are strictly forbidden to open the chassis for operation and use.
10. Do not continue to operate and use the machine if it is suspected that there is a fault.
11. When connecting the battery, make sure that there are no other metal objects on your hands to avoid short circuit of the battery and burn your body.
12. Based on safety and performance considerations, the installation environment should meet the following conditions:
1) Dry: Do not immerse in water or rain;
2) Cool: temperature between 0 ℃ and 40 ℃;
3) Ventilation: keep no foreign matters in 5CM on the shell, and other end faces are well ventilated.
Installation and use method of inverter
1) Place the converter switch in the OFF position, and then insert the cigar head into the cigarette lighter socket in the vehicle to ensure that it is inserted in place and in good contact;
2) Confirm that the power of all electrical appliances is below the nominal power of G-ICE before use. Insert the 220V plug of the electrical appliance directly into the 220V socket at one end of the converter, and ensure that the sum of the power of all electrical appliances connected to the two sockets is within the nominal power of G-ICE;
3) When the converter switch is turned on, the green indicator light is on, indicating normal operation.
4) The red indicator light is on, indicating that the converter is turned off due to overvoltage/undervoltage/overload/over-temperature.
5) In many cases, due to the limited output of the vehicle cigarette lighter socket, the converter will alarm or turn off during normal use. At this time, it can return to normal as long as the vehicle is started or the power consumption is reduced.